Fencing to Mitigate Traffic Sights and Sounds

If your side or rear yard has a clear view of a street, odds are, the sight and sound of the traffic can be anywhere from a minor imposition on your enjoyment of your yard to a downright annoyance. If you suffer from this problem, there are many ways to add privacy by screening out potential gawkers and reducing the noise of the traffic.

If you are lucky enough that the street that you want to screen is a quiet one, with no chance of an increase in traffic or of being widened, then the ubiquitous wood fence can be a decent option. However, with the inevitable wood shrinkage, most wood fences wind up with vertical gaps that allow passersby a view of your yard and let in sound. Even if these are not issues for your situation, then the need for maintenance or replacement due to weathering down the road may send you searching for fencing options.

There are many options to choose from such as vinyl, masonry, stone and composite fencing. You might even opt for a combination of wrought iron and landscaping to mitigate the impact of the traffic on your yard. While all of these materials have pros and cons, I’d like to share the solution that I chose for a side yard project recently. This choice was less costly than masonry or stone (both really good choices for sound mitigation and longevity), a bit more expensive than vinyl (to me, most look fake and don’t seem dense enough to mitigate the sound well.), and needed less room, maintenance and time for plant growth than a wrought iron and landscape option.

This particular side yard had been unfenced for about 40 years. Initially, a rural two lane road was separated from the house by about 20 feet of bar ditch (right of way) in addition to 25 feet of side yard. Over the years, traffic increased until finally, what was once a quiet rural road, was widened to a 5 lane thoroughfare. In doing so, 11 feet of the side yard was taken for the project. Now there was only about 9 feet of ROW between the curb and lot line that included a four foot wide sidewalk. The road pavement was now closer to the house than where the original lot line used to be. The traffic noise was a constant imposition, even inside the house and the traffic (vehicle and foot) felt on top of anyone trying to enjoy the patio or use the side yard.

The product that I chose for this fence, to serve as both a visual screen as well as a sound barrier, was a composite material, Trex, that has been used extensively for over 15 years in outdoor uses such as decking, outdoor trim, garden boxes and fencing. It is an environmentally friendly product made from reclaimed/recycled wood and plastic fibers. I chose the Trex Seclusions Privacy Fencing to enclose the side yard and connect into the existing chain link fence of the year yard. There are many styles and colors to choose from and many more good things I could tell you about this product, however to keep from making this post extremely lengthy, please visit the Trex website for more information. (I have no financial interest in this company, I am just a longtime fan of its products.)

As for how the project turned out, everyone involved considers it a huge success. The pictures in this post are of the project just after completion. The traffic noise outdoors and inside (especially noticeable improvement in the bedrooms that are on that side of the house) was greatly reduced. The side yard actually became usable again from the definition and privacy that the fencing provided and the patio area was once again something that could be enjoyed without feeling like being in a fishbowl.

If you need any assistance putting together a solution for a problem in your yard, you can find my contact information on my garden coach web page.

Design This – Pendant from Dead iPod

What to do when your dead iPod with the custom engraving that is special to you doesn’t work anymore? You can’t just throw it away. Let Etsy’s alchemy section come to the rescue! Earlier this year I found an alchemy request titled “Make me a pendant out of a dead iPod”. At first I was stumped for an idea, then I decided a nice wooden frame sounded like a good way to accomplish this. I sent a convo to see if the requestor liked my idea and if so I needed a few questions answered so that I could make a bid. After a bit of discussion, the requestor decided to accept my bid saying, “I like the idea of a wooden frame with embellishments from the circuit board. The contrast of natural/industrial is great.”

After I received the iPod from my customer, I had to take it apart to see what was available to become part of the pendant. I took photos of the pieces(#1) and sent them to my customer to see if there was anything that especially caught her eye. The only real imperative at this point was to incorporate the custom engraving and to have an open backed frame in a dark wood color, so I mocked up a few frame and circuit board embellishments for us to contemplate(#2). The aspect ratio of the pendant mock ups kept bothering me though. I didn’t like that the pendant would be wider than it was tall. I started to think about how I might make a rounded frame. Inspiration struck and I sliced some sections off a small, cured sycamore branch and cut out an opening. I sent a photo of this to my customer and after some minor adjustments, it was a winning idea.(#3)

Now that I knew what my frame opening would be like, I needed to cut out the metal section. The iPod case was a bit tougher than I had expected, so I had to buy some less fine and stronger blades for my jewelry saw. After getting the section cut off that included the inscription, we needed to decide on what would show through the open back of the pendant frame. We finally decided on a section of circuit board.

After securing the metal piece with the engraving to the circuit board section and then the wood frame front and backs, came the part that I was really looking forward to. I had had an idea for filling the gap between the wood frame on the edges that my customer agreed to let me use.(#4) I had not worked with the materials myself before, but had seen it used in many similar circumstances and really wanted a chance to try it out myself. I thought the gap would look great filled with inlaid crushed stone. Malachite would be a great color to coordinate with the green of the circuit board. I’m pleased to say that it worked out just like I had wanted it to.

Now the only thing left was to attach some hand formed “jump rings” so that my customer could attach her pendant to a necklace and send off photos for final approval from my customer.(#’s 5 & 6) I’m happy to say that she thought the pendant was beautiful and loved the way that it turned out. It is rewarding to be able to rise to a challenge like this and successfully turn someone’s idea into reality.

Please e-mail Eclectic Design Choices or request a custom item from EDCCollective if you have a custom project that you would like to see if I can help with.

Thanks for the Treasuries - May 2010

During May, seven of EDCCollective's items found their way into Etsy treasuries. One of them, my "Love the Grape" purse charm was even featured twice! Below is a collage of the 7 items that were showcased during May. (Click on the collage to see a larger view.)


It is really cool when one of my items is featured by the treasury makers. To thank them, I have listed below (in alphabetical order) links to the 6 different shops that featured at least one of my items, as well as an item from their shop that I like.

Enjoy window shopping and I encourage you to click on the shop links of anything that pleases your eye.

BellaVioletta
BellaVioletta's upcylced art includes embellishments, like these colorful peace signs and more, journals, stickers and pins.


CorkyCrafts
Wine-related products make the perfect gifts! If you are a wine connoisseur who happens to appreciate hand made items, look no further.


GaBeadz
Exclusive handmade jewelry designs such as this stunning necklace are presented by GaBeadz.

GlassnWood
This husband and wife duo creates amazing nature themed wood carvings, such as this blue heron, and stained glass items.

HotdogCrafts
Awareness ribbon, natural beauty, angels, ham radio callsign buttons and polished stone and paper jewelry are some of the great gift items you will find at Hotdogcrafts.

rhradcliffeDesigns
Amazing works of art from original watercolors to prints to ACEOs are available at rhradcliffeDesigns.

Plants to Avoid

If you were asked what plant someone should stay away from in the great outdoors, your first thought is likely to be poison ivy. While that is a very good answer, I’d like to introduce a couple of others that can cause quite a bit of pain if you happen to brush up against them.

The two plants that I would like to introduce you to are commonly know as stinging nettle and Texas bull nettle. According to a quick check online, stinging nettle can be found throughout much of the world whereas TX bull nettle may be limited to the southern central US and Mexico.

Stinging nettle can be an inconspicuous plant growing among pasture grasses or in other areas as seen in the first photo. This plant has tiny stinging hairs that will cause a painful site reaction when touched. The pain often subsides in a few minutes, however I have known it to cause welts and prolonged pain/discomfort in some individuals. Often, when I have not managed to avoid it and am experiencing its painful sting, I have had to look closely for the offending plant because it can blend in so well. Strangely enough, the young leaves are supposed to be able to be prepared properly and eaten. I’m not planning on giving that or puffer fish a try though.

A much larger and more noticeable plant with pretty white flowers in the spring is Texas bull nettle. As you can see in the second photo, this plant is a bit easier to see and therefore to avoid. I had the good fortune to find out about this plant before touching it, as its sting is reported to cause more pain and for a much greater length of time than stinging nettle. Stinging nettle is bad enough for me. I have no curiosity about just how bad bull nettle’s sting is.

Before you go on an eradication spree however, you need to know that these plants are host plants for some butterflies so they are an important part of the ecosystem. Also, don’t forgo enjoying the great outdoors for fear of brushing up against them. Wearing long pants and tall socks while hiking around and watching where you put your hands should keep you pain free. Hopefully the information in this article will allow you to identify and avoid these two plants and thus keep you from finding out why the plants are referred to as “stinging” nettles.

Custom Birthstone Jewelry

Ever since I did a custom bracelet order for a customer last summer using colored crystals to represent the birthstones of the people to be represented in the bracelets, I have pondered jewelry designs that could easily be customized for customers with the birthstone colors of their choice. After much thought and research, I have come up with designs, using materials that I am confident that I can replenish as needed, for custom birthstone necklaces and earrings.

For the necklaces, I envision representing mom and dad with inline crystal sections. The child(ren) are represented in a pendant crystal section. This can be added to as a family grows. Of course, anyone dear to you can be represented in any of the crystal sections.

I am currently offering two basic necklaces at a couple of different lengths and price points. Custom lengths are also available. The first photo shows a 17 ½ inch necklace made with silvertone figaro chain and findings. It has two inline crystal sections and a central pendant crystal section. The second photo shows a 16 inch necklace using the same layout of crystal sections, however with your choice of gold plated (as shown in the second photo), or silver plated figaro style chain and findings.

Custom birthstone crystal earrings are also available. The base style uses three birthstone colors of your choice as shown in the first photo. They are made with gold plated or silver plated ear wires and findings.

Custom birthstone jewelry is a great way to keep your loved ones close at all times. It also makes a great gift for a new mom, grandmother, etc. Who you choose to represent is up to you. Let me know the months that you want represented and in which crystal sections on a necklace or in what order for earrings. My contact information can be found at EclecticDesignChoices.com.

Design This – Earrings to Match Costume

The perfect accessories for a costume are like the icing on a cake. They should complement the costume while supporting the theme and not detract from it. Whether your costume is for a play, Halloween, a party, a convention or other fun event, I’m always happy to brainstorm a solution to your needs.

A general Etsy alchemy request for “Earrings To Match Harlequin Jester Costume” caught my eye. There was a sketch of the costume and it suggested to me some materials that I had on hand. The request also included a need for hypoallergenic ear wires. I stock a variety of colors of niobium ear wires for people with sensitive ears so I was off to my supply room to put together a mock up for the request.

The basic pattern of the costume was an angular, geometric one in black and white. I had some square, white shell beads as well as some black gemstone cubes that I thought would lend themselves to this project. I included a gray pair of niobium ear wires in the photo of my initial design idea. (photo #1)

The person that placed the request liked the basic design but wondered if I could add some of the blue accent color in the sketch. I had just picked up some awesome blue sponge coral beads that seemed to be the perfect color and had some that were small rounded cubes that I suggested adding as a dangle from my original design. I also suggested a dark blue pair of niobium ear wires as an option. (photo #2) After looking at a photo of my other available blue sponge coral beads, my customer decided to go with the dangling cubes and the dark blue ear wires that I had suggested.

All that was left now was to make up the earrings (photo #3) and get them shipped to my customer. I think the shapes and colors of the materials of the earrings will be a good fit for the design of the costume and the niobium ear wires will both add a bit of color and provide a hypoallergenic solution for comfortable wearing for sensitive ears.

If you would like for me to brainstorm a solution to your accessory needs, please click on the “request custom item” or “contact EDCCollective” button in my shop.

Thanks for the Treasuries - April 2010

April tied February's record of thirteen different items from EDCCollective having been featured in Etsy treasuries. One of them, my corn maiden style feather pendant was even featured twice! Below is a collage of the 13 items that were showcased during April. (Click on the collage to see a larger view.)


I really appreciate being featured by the treasury makers. To thank them, I have listed below (in alphabetical order) links to the 7 different shops that featured at least one of my items, as well as an item from their shop that I like.

Enjoy window shopping and I encourage you to click on the shop links of anything that pleases your eye.

BellaVioletta
BellaVioletta's upcylced art includes pins like this beautiful butterfly brooch, journals, stickers and other embellishments.


BerryBlueCreations
This talented crafter has a wide range of items to offer you, from art dolls and stethoscope covers to custom graphics.


CherylsPurpleCow
Cheryl works diligently to raise awareness for a wide range of great causes. You will find a variety of awareness and other jewelry in her shop.

CorkyCrafts
Wine-related products make the perfect gifts! If you are a wine connoisseur who happens to appreciate hand made items, look no further.

GaBeadz
Exclusive handmade jewelry designs such as this stunning necklace are presented by GaBeadz.

GemuineCreations
Fine handmade jewelry and accessories for all occasions such as this lovely wire wrapped goldstone pendant.


PlainSpirit
Shop for OOAK and vintage sterling silver jewelry and gifts such as this amazing inlay bolo tie.